BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 5)

Revised 12/28/2012 Page 5 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
19.Zip tie fuel lines so they do not kink & zip tie
the wire harnesses securely. 20.Cut and splice into the return fuel line, install
T into fuel and tighten clamps. Position for
clearance, zip tie & secure.
21.Install the tank & Aluminum tank support
member. Make sure you are fitting the Y & air
box into position. NOTE this is a tight fit. 22.Remove the clear line on rave valve solenoid
& Install check valve. Turn the blow off to down
position. Zip tie the hoses on.
23.Cut hose between rave valve & solenoid. In-
stall the check valve inline Turn the check valve
down & zip tie lines on. Make sure routing of
hoses have good clearance. 24.Install intercooler using 2– hose claps on
cross bar, do not tighten, install fan route power
to adapter harness , install 90 degree boost fit-
ting in to inner cooler tank