BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 3)

Revised 12/28/2012 Page 3 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
7.Remove the throttle bodies & reed cages from
the machine. 8.Remove & replace the reed pedals. DO NOT
mix them up. The new reeds are turbo reeds &
there are inner & outer reeds. Reinstall back in
engine & install the throttle bodies.
9.Unhook the PTO side coil wire & plug in the
green wired plug on the E-Key into the coil
(PTO side). Plug in the yellow wired plug of the
E-Key to MAG side connector. 10.Install the power adapter cable into the open
fuse holder. Install supplied fuse.
11.Hook up the ground right below the fuse
holder on the foot rest with the stock bolt.
Tighten the bolt so wires are pointed to the top
of the chain case. 12.Remove fuse holders from the stock oil tank
& install the power harness on the end of the
power adapter cable (as seen in picture). NOTE
make sure red wire goes to red wire.