BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 2)

Revised 12/28/2012 Page 2 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
1. Remove the instrument, side panels & Hood/head
light/air box module. Remove the Air box at throttle
bodies, seat, tank & body panels.
2.Carfuly remove temp sensor for later use in turbo
install.
3. Remove the stock muffler/can & EGT. Remove the
stock rubber muffler/can isolators from the bottom of
the muffler/can.
4. Remove hood from headlight assembly & flip
upside down. Break off the weld dots on the air box
assembly. Pull apart the air box assembly. Discard
the lower air box & white air box tube.
5.Cut the upper air box matching both sides on
the cut (as seen in picture). 6.Cut the upper hood/air box assembly as seen in
picture for clearance purposes. Cut remaining
weld dots off of the upper air box.