BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 8)

Revised 12/28/2012 Page 8 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
37.Install the inlet apply high temp silicone on
both sides of the doughnut. If you have a non-
Tial exhaust install the bolts now. If you have a
Tial exhaust then install the inlet clamp. 38.Install the waste gate solenoid & plug in. Use
the Velcro supplied to mount the solenoid. Use a
heat gun to activate the glue on the Velcro. The
hose that is headed upward goes to waste gate.
39.TIAL ONLY. Install the waste gate on the
inlet. Plug the remaining holes in the Tial waste
gate. You will not use the coolant fitting option
on this waste gate. As seen in picture. 40.Drill the lower side panel as seen in picture.
If you have a Tial the hole will be a 3-1/2” hole
saw . If you have a nonTial drill hole to 2-1/2”
hole saw.
41.Install heat tape to the lower inside side
panel. Install the 2-1/2” charge tube do not
tighten the hose clamps yet. 42.Test fit the head light assembly to the inter-
cooler mount bracket. Tighten all the hose
clamps into position making sure the head light
assembly & charge tubes fit correctly (no rub).