Code 3 RLS - Manual (Page 15)

1 5
depressed a second time. Depressing the center switch will set all four outputs of the selected mode to OFF.
Please refer to the RLS Auxiliary Relay Control Module, User Manual (p/n 10947) for detailed instructions
and further cautionary information on the installation and wiring of the RLS Auxiliary Relay
Module.
Contol Head Wiring
M A I N T E N A N C E
Your Code 3 3990 series siren has been designed to provide trouble free service. In case of difficulty, see
Troubleshooting (page 16,17 ). Also check for shorted or open wires. The primary cause of short circuits has
been found to be wires passing through firewalls, roofs, etc. If further difficulty persists, contact the factory for
troubleshooting advice or return instructions. Public Safety Equipment, Inc. maintains a complete parts
inventory and service facility at the factory and will repair or replace (at the factory's option) any unit found to be
defective under normal use and in warranty. Any attempt to service a unit in warranty by anyone other than a
factory authorized technician without express written consent by the factory, will void the warranty. Units out of
warranty can be repaired at the factory for a nominal charge on either a flat rate or parts and labor basis.
Contact the factory for details and return instructions. Public Safety Equipment, Inc. is not liable for any
incidental charges related to the repair or replacement of a unit unless otherwise expressly agreed to in writing.