Code 3 RLS - Manual (Page 3)

3
3999/3999R
- Primary Tones: Wail, Yelp, Hi-Lo, Air Horn
- Secondary Tones: HyperYelp, HyperLo
- 6 auxiliary lighting controls
- Integral Arrow Stik Control
- NIGHTPROBE
TM
Spotlight controller
optionally available
- 8 additional auxiliary relay outputs
optionally available
The following features are standard in the RLS series
sirens (tones and sequences may differ with model and
options):
Instant-On- There is no " ON/OFF " switch. Selecting
a n y
siren function, or keying the microphone will activate the
selected siren function, assuming the siren is properly
installed and the vehicle's ignition is switched on.
Park Kill- This feature deactivates the siren tones and
drops-out the Level 3 lighting when the vehicle is shifted
into park. Once PKILL is activated the siren will remain
deactivated until the vehicle is shifted into drive and an
action occurs such as depressing one of the siren
control switches, changing the position of the lighting
level switch or keying the microphone. Any of these
actions will cause the siren tones to start again.
Adjustable Backlighting- Backlighting is independent
of siren power. Allows connecting to dimmer if desired.
Automatic Short Circuit Protection- The siren will
sense a short circuit on the speaker terminals and
automatically go to standby until the fault is removed.
Once the fault is removed the siren will return to normal
operation.
Lighting Level "3 " Dropout- When vehicle is shifted
to PARK and the PKILL feature is connected, Level 3
lighting will dropout. This is a power down mode and can
be defeated by setting the 4 -position rear dip switch to the PKILL "OFF" position on the lighting board. This is
indicated by the "red" LED extinguishing.
Scroll Mode- Setting the slide switch on the rear of the siren to the SCROLL position will put siren in scroll mode.
This will allow "scrolling" through tones utilizing sharp taps on the horn ring, or a switch, via the Remote siren
input. In this mode holding the horn ring for prolonged durations will produce the Airhorn sound. See OPERATION
section for further details.
Hit-n-Go Mode - Setting the slide switch on the rear of the siren to the Hit-N-Go position will put the siren in the
Hit-n-Go mode. This mode will be most familiar to existing users. A seven second override is
standard for all tones when activated by the Remote input. See OPERATION section for details.
Automatic Siren Tones - Industry standard Wail, Yelp, and Hi-Lo tones.
AIR HORN Tone - Electronic AIR HORN sound.
Instant Public Address - Public Address override of all siren functions when the microphone Push-to-Talk key is
pressed.
Manual/Air
Horn
P u s h -
buttons
3-Level
Lighting
S w i t c h Switch D
Switch E
Switch F
Switch C Switch A
Switch B
Figure 1 - 3999 Control Panel
Special
Function
S w i t c h e s
Switch D
Switch E
Switch F
Switch C Switch A
Switch B 3-Level
Lighting
Switch
Manual
Air Horn
Switches
Figure 1A - 3997R Control Panel
Special
Function
Switches