Cuddeback E FAMILY - Manual (Page 10)

Test Item
Press MODE until the
TESTS LED is illuminated.
After a short delay WALK
will be displayed and walk-test is enabled. When
test mode is enabled the RED LED (inside the flash
module) will illuminate
when a subject is detected.
Walk back and forth (not
toward) the camera to
verify the detection zone.
Pressing MORE from the WALK test will display
TEST CAM. See Appendix E: Troubleshooting,
Service & Support for instructions on how to use
these commands to troubleshoot and test your camera.
Command Item
Press MODE until the
COMMANDS LED is
illuminated. The first menu
item is BATTERY which
displays the battery level. Press MORE to display
additional Command items. When a Command
item is displayed press UP or DOWN to activate
the command (if required).
BATT –––. Battery level displayed as FULL, GOOD,
LOW or DEAD. Press UP or DOWN to display
more information on battery status:
BD – Battery Days shows how long the camera
has been operating on this set of batteries. This
count is reset to 0 when the batteries are removed.
BI – Battery Images is a count of how many
battery images have been taken on this set of
batteries. This value is calculated based upon Diagram of “Walk” test
16 17