Cuddeback E FAMILY - Manual (Page 27)

2. RESET is the first command. Pressing UP
will reset the camera to factory settings. This
command is useful if you think the camera
settings are incorrect. We always recommend
resetting the camera before performing
additional diagnostic steps. Press UP and
confirm and reset the camera.
3. BATTERY level will be displayed next. If
Battery level is LOW or DEAD we recommend
you replace the batteries. Press UP to view the
Battery Image and Battery Day counters.
4. BATTERY LOAD test is next. Press UP to
begin the battery load test. This test will
display a value from 10 (low) to 99 (high).
If the number is below 50 we recommend
you replace the batteries.
5. FILTER verifies the camera filter works
correctly. Press UP to test and you should
see the filter move inside the camera.
6. IR LED tests the camera’s illumination
LEDS Press UP to turn on the LEDs.
NOTE: for Black Flash you will not be able
to see the LEDs turn on. Use a cell phone
camera to view the LEDs. (Note – some
cell phones, like the iPhone 5S, will not
display the IR LEDs.)
7.
SD CARD verifies your SD card is functioning.
Press UP to test your SD card. This test will
write a file to the SD card and read it back to
verify the SD card is functional.
8. IMAGE - Press UP or DOWN to take a still
image. You can view this image on your PC
or other viewing device to assure it is OK.
9. VIDEO - Press UP or DOWN to record a
video. You can view this video on your PC
or other viewing device to assure it is OK.
For additional product support visit http://support.
cuddeback.com. You can also email us your ques-
tions by visiting http://cuddeback.com/email.
50 51