Cuddeback E FAMILY - Manual (Page 6)

Install batteries
Install batteries by removing the 2 battery door
thumb screws and removing the battery door. Insert
8 AA batteries as shown. Make sure to observe the
correct polarity. BATTERIES CAN EXPLODE,
LEAK ACID, OR IGNITE IF INSERTED
INCORRECTLY. After batteries are inserted correct-
ly, reinstall the battery door and fully tighten the 2
thumb screws.
We recommend Rayovac, Duracell, or Energizer
brand batteries only. (Choose batteries carefully -
there is a difference, especially in cold temperatures).
Lithium batteries provide better performance in cold
(below freezing) temperatures. Refer to Appendix B:
Battery Life for more information on maximizing
battery life.
Install SD Card
Insert the SD card into the camera label side down.
Do not force the card. If it does not go in easily,
check to make sure you are inserting it correctly.
You will break the card socket if you force the card.
IMPORTANT
Be sure to
insert batteries
with correct
polarity!
+
–
+
–
+
–
+
–
Insert SD card
with label facing
down or towards
the back of the
camera
(SD/bottom panel
door open)
8 9