Cuddeback E FAMILY - Manual (Page 12)

✓ Lifetime Days is how many days the camera has
been operating.
✓ Run Days is how many days the camera has
been armed.
✓
Lifetime Images is how many images the camera
has recorded.
✓ Lifetime Flash Image is how many flash images
that camera has taken.
Settings Item
Press MODE until the
SETTINGS LED is displayed.
This is where camera delay
and video length is set. Press MORE to display these
settings. (In advanced mode additional settings are
enabled, see Advanced Mode section in this manual).
Delay – this is the delay between images. Settings
are FAP (Fast-as-Possible which is about 1 second)
to 1 hour. Press the UP or DOWN key to select.
Video – press UP or DOWN to select the length of
the video or OFF if you do not want to record videos.
Armed Item
Press MODE until the ARM
LED is displayed. The word
ARMING will flash on the
LCD and then a 30 second
count down will begin, after which the camera will
arm and begin operation. Note – if the SD card is
not installed or not functioning correctly the message
CHECK SD will be displayed.
Armed Info. When the camera is armed you can
suspend operation and view the status and images
count on the SD card or Internal Memory:
1. When the camera is armed press UP or DOWN.
The battery level will be displayed.
2. Consecutive pressing the UP or DOWN key will
display this data as appropriate. Note that SD data
will only be displayed if an SD card is installed; and
IM data will only be displayed if images are saved in
Internal Memory.
a. SD IMAGE is the number of images on the
SD card
20 21