Routing the air brake cable – Dynojet 250iP: Air Brake and EEC Kit User Manual
Page 18
Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
A I R B R A K E A N D E E C K I T
Air Brake
14
R
OUTING
THE
A
IR
B
RAKE
C
ABLE
Before proceeding with the rest of the air brake installation it is necessary to connect
the shop air and check the brake pad clearance.
1
Open the front panel of the control panel interface (CPI) to access the breakers
and Breakout board.
2
Route the air brake cable from the air brake solenoid to the CPI.
Note: The CPI end of the air brake cable splits in two.
3
Connect the cable with the two black wires to the Breakout board wiring block
labeled Brake.
4
Attach the 4-pin connector to port P7 on the CPI board.
Figure 15: Routing the Air Brake Cable
P7 on the
CPI board
brake wiring block
on breakout board