Dynojet 250iP: Air Brake and EEC Kit User Manual
Page 37
I N S T A L L A T I O N G U I D E
Replacing the Drum Module Hood, Side Drum Cover, Center Panel, and Tire Carriage—200i/250i
Version 1
Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
33
REPLACING THE DRUM MODULE HOOD, SIDE DRUM COVER,
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CENTER PANEL, AND TIRE CARRIAGE—200I/250I
Refer to “Replacing Pit Cover Plates and Upright Brace—200iP/250iP” on page 34 for
model 200iP/250iP dynos.
1
Secure the center panel to the dyno carriage using the six 1/4-inch screws
removed earlier. Refer to Figure 4 on page 6.
2
Secure the three carriage clamps and shims using two 5/16-inch bolts and washers
each. Refer to Figure 4 on page 6.
3
Secure the nut block and shim using two 5/16-inch bolts and washers. Refer to
Figure 4 on page 6.
4
Replace the tire carriage by sliding it under the carriage clamps. Refer to Figure 3
on page 5.
5
Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block. Refer to Figure 3 on page 5.
6
Secure the bearing bracket to the carriage using four 1/4-20 x 5/8-inch pan head
screws. Refer to Figure 3 on page 5.
7
Using the hand crank, screw the carriage through the nut block and into the
screw support bracket. Refer to Figure 3 on page 5.
8
Secure the right side drum cover to the dyno frame using the six 1/4-20 x 5/8-inch
pan head
screws removed earlier. Refer to Figure 2 on page 4.
9
Secure the top of the right side drum cover to the dyno using the two
1/4-20 x 5/8-inch pan head screws removed earlier. Refer to Figure 2 on page 4.
10 Secure the drum module hood to the dyno using the eight 1/4-20 x 5/8-inch pan
head screws removed earlier. Refer to Figure 1 on page 3.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less than
0.64 centimeters (0.25 inches). Refer to page 22 for instructions on adjusting
the gap.