Dynojet 250iP: Air Brake and EEC Kit - Manual (Page 27)

I N S T A L L A T I O N G U I D E
EEC Finger Guards—200iP/250iP
Version 1 Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
23
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EEC FINGER GUARDS—200IP/250IP
The 200iP/250iP motorcycle pit dynos also benefit from the EEC kit. The EEC finger
guards provide extra protection from the drum by regulating the distance between
the drum and the chassis. The placement of the finger guards can be manually
adjusted.
Refer to “EEC Finger Guards—200i/250i” on page 20 for model 200i/250i dynos. Refer
to “Air Brake” on page 3 for air brake installation instructions.
I NSTALLING THE EEC F INGER G UARDS
If you are not installing the EEC finger guards skip this section and refer to “Door
Safety Switch” on page 29 for door safety switch installation instructions.
1
Remove the right pit cover plate. Refer to “Removing the Pit Cover Plate and
Upright Brace” on page 7.
2 Remove the four 3/8-16 x 1/2-inch screws securing the left pit cover plate to the
dyno chassis and set aside.
3 Remove the left pit cover plate.
Note: The drum guard mount is attached to the left pit cover plate.
Figure 23: Removing the Left Pit Cover Plate
screw
left pit cover plate
drum guard mount