Installing the bearing, Installing the bearing -14 – Dynojet 224: Eddy Current Brake User Manual
Page 18
Advertising
Model 224 Above Ground Eddy Current Brake Installation and User Guide
C H A P T E R 1
Eddy Current Brake Installation
1-14
I
NSTALLING
THE
B
EARING
The eddy current brake can be installed on either side of your dyno, the installation
instructions are the same.
1
Install the bearing using two 1/2-13 x 1.25-inch flanged bolts. Leave the bolts
loose.
Note: If you are retrofitting an early model dyno which does not have the bearing
mounting holes, refer to the instructions in Appendix C.
Figure 1-8: Install the Bearing
bearing
bearing mounting
holes
Advertising