Dynojet 224: Eddy Current Brake - Manual (Page 20)

Model 224 Above Ground Eddy Current Brake Installation and User Guide
C H A P T E R 1
Eddy Current Brake Installation
1-16
I NSTALLING E DDY C URRENT B RAKE
1 Place the keyed yoke onto the eddy current brake shaft.
2 Line up the eddy current brake yoke with the driveline assembly.
3 Slide the brake frame towards the dyno frame until they touch. Make sure the
brake yoke is aligned with the driveline.
4 Secure the yoke to the driveline assembly using the four bolts removed earlier.
Torque the bolts to 70 foot-pounds.
Figure 1-11: Install the Brake Assembly
yoke
driveline assembly