Dynojet 224: Eddy Current Brake - Manual (Page 49)

B A S I C D Y N A M O M E T E R O P E R A T I O N
Loading the Car
Version 3 Model 224 Above Ground Eddy Current Brake Installation and User Guide
3-3
7 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
8 Set the vehicle’s emergency brake.
9 Secure the non-drive wheels using the provided tire chocks. Do not use tire
chocks for four wheel drive vehicles.
10 Attach the tie-down straps.
Rear Wheel Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle. Attach additional tie-down straps from the rear of the vehicle as shown
in Figure 3-2.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle.
Front Wheel Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle. Attach additional tie-down straps across the front of the vehicle to
form a crisscross.
Four Wheel (All Wheel) Drive
• Attach two tie-down straps from secure anchor points to the rear of the
vehicle. If the vehicle is equipped with a rear steering system, attach additional
tie-down straps across the rear of the vehicle to form a crisscross.
• Attach two tie-down straps from secure anchor points to the front of the
vehicle. Attach additional tie-down straps across the front of the vehicle to
form a crisscross.
Figure 3-2: Attach Tie-down Straps
rear wheel drive front wheel drive four wheel drive