Dynojet 224: Eddy Current Brake User Manual
Page 28
Advertising
Model 224 Above Ground Eddy Current Brake Installation and User Guide
C H A P T E R 1
Eddy Current Brake Installation
1-24
4
Verify jumpers J1 and J2 are set for the eddy current brake as shown in
Figure 1-19.
The air brake will be activated when the dyno electronics power is turned off or
when the red button on the pendant is lit. The eddy current brake is used for load
control.
Figure 1-19: Wire the Breakout Board
jumpers
J1 and J2
load control
temp
speed pick-up
Advertising