Loading the car – Dynojet 224: Eddy Current Brake User Manual
Page 48
Model 224 Above Ground Eddy Current Brake Installation and User Guide
C H A P T E R 3
Loading the Car
3-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE CAR
Use the following steps to load a car on the dyno.
Note: For more information about lift operation, refer to the instructions
included with the lift.
1
Verify the dyno electronics power is on and connected to your computer.
2
Make sure you are in the MakeRun screen.
3
Set the dyno brake on by pressing the red button on the hand held pendant.
4
For four or all wheel drive vehicles, measure the wheel base on the vehicle and
adjust the 224-4WD dyno to the dimension before driving the vehicle on the
dyno.
5
Drive the vehicle onto the dyno and align the vehicle straight with the dyno.
6
Stop the vehicle when the drive axle(s) is centered on the drum(s).
Figure 3-1: Center the Drive Axle(s) on the Drum(s)
center drive axle on dyno drum
adjust wheel base of
224-4wd dyno
center drive axle on both dyno drums
rear or front wheel
drive vehicles
four or all wheel
drive vehicles