Habey BIS-6650 User Manual
Page 42
Bootup Numlock State
[On]
Show Full Logo
[Enabled]
Boot Option Priorities
Boot Option #1
[SATA PM:WDC WD10… ]
Boot Option #2
[UEFI: Built-in EFI…]
Hard Drive BBS Priorities
→←：
Select Screen
↑↓：
Select Item
Enter：Select
+/-：Change Opt.
F1：General Help
F9：Optimized Defaults
F10：Save&Exit
ESC：Exit
Version 2.10.1208. Copyright（C）2010 American Megatrends，Inc.
Setup Prompt Timeout
Number of seconds to wait for setup activation key. 60s is the maximum seconds of timeout. If
don’t press setup key within the preset time, system will continue to start.
Bootup Numlock State
This function allows users to activate Numlock function when system boots up.
[ON]:Numlock open when boot up
[OFF]: Numlock under cursor control
Show Full Logo
[Enabled]: Computer boot screen will show supplier’s LOGO.
[Disabled]: Self-detect info will show when system boots
Boot Option #1/2
System will detect devices according to the preset sequency until to find a boot device. Option
#1 is the prior boot device.
Hard Drive BBS Priorities
This option contains HDD that can be used as boot device. If multiple HDDs in this option,
priority should set for these HDDs, then the prior one will show in Boot Option #1.
36