Kontron CP384 - Manual (Page 26)

Kontron Modular Computers GmbH ID 31440, Rev. 01
P R E L I M I N A R Y
Re
vNr. = CP384
-
31440
_01 -
06
0503
/14
4227
Page 1 - 10
Introduction CP384
1.6 Technical Specifications
Table 1-3: CP384 Main Specifications
GROUP/
INTERFACE
TYPE DESCRIPTION
DIO ProComm
Controller and
Related
FPGA Logic Device Provides CompactPCI interfacing and IO control logic
Peripheral
Memory
CapROM 4 kbit (512 byte) EEPROM
CompactPCI
Interface
(See note at foot
of table)
Realized on 132-pin,
female, six row connec-
tor (standard CPCI type
connector for CON1) Bus Width: 32-bit, Bus Speed: 33 MHz
64 kB memory space, non-prefetchable
Utilizes interrupt line INTA
Software Driver Infor-
mation PCI Header:
Device ID:
0x5555
Vendor ID: 0x1556
Class Code: 0x110000
Subsystem Device ID: 0x0121
Subsystem Vendor ID:
0x1518
PCI Interface VI/O voltage is neither relevant nor used
Master / Slave Function-
ality Only slave functionality provided
Digital Input and
Output Interface
One 62-pin, female,
three row, D-sub con-
nector Supports up to 16 digital input channels and 8 digital output
channels
Indicators Front Panel LEDs One green and one red LED to indicate operational status
General
Form Factor 3U, 4HP
Mechanical Conforms with IEEE 1101.1
System Power Con-
sumption only + 3.3V: maximum 600 mW (all IO channels activated)
Temperature Range Operational: 0ºC to +60ºC Standard
Storage: -40ºC to +115ºC
Climatic Humidity 93 % RH at 40°C, non-condensing (acc. to IEC 60068-2-78)
Dimensions 100 mm x 160 mm single height Eurocard
Board Weight 180 grams
Note ...
The Device ID and Vendor ID refer to the chip manufacturer. In the Class Code
value given, “11” relates to the data acquisition and signal processing control-
lers and “0000” relates to the DPIO modules. Subsystem Device ID and Sub-
system Vendor ID are defined by Kontron.