Kontron CP384 - Manual (Page 4)

Preface CP384
Kontron Modular Computers GmbH ID 31440, Rev. 01
P R E L I M I N A R Y
Page iv
Re
vNr. = CP384
-
31440
_01 -
06
0503
/14
4225
Chapter
2
2. Functional Description ..........................................................................................2 - 3
2.1 General Information .................................................................................2 - 3
2.2 Board Level Interfacing Diagram .............................................................2 - 3
2.3 Digital Input Signal Conditioning ..............................................................2 - 5
2.4 Digital Output Signal Conditioning ...........................................................2 - 5
2.5 Optoisolation ............................................................................................2 - 5
2.6 DIO ProComm Controller .........................................................................2 - 5
2.7 System Interfaces ....................................................................................2 - 5
2.7.1 Digital Input and Output Interface ....................................................2 - 6
2.7.2 CPCI Interface and Pinout ..............................................................2 - 8
2.8 CapROM EEPROM ...............................................................................2 - 10
2.9 Monitor and Control (M/C) .....................................................................2 - 10
2.10 Software .................................................................................................2 - 10
Chapter
3
3. Installation ....................................................................................................3 - 3
3.1 Hardware Installation ...............................................................................3 - 3
3.1.1 Safety Requirements .......................................................................3 - 3
3.1.2 Installation Procedures ....................................................................3 - 4
3.1.3 Removal Procedures .......................................................................3 - 5
3.2 Software Installation ................................................................................3 - 5
Chapter
4
4. Configuration ................................................................................................4 - 3
4.1 Jumper Settings .......................................................................................4 - 3
4.2 Digital Input Signal Requirements ...........................................................4 - 3
4.2.1 Channels .........................................................................................4 - 3