Kontron VMP3 - Manual (Page 116)

NetBootLoader VMP3
Page 5 - 32 © 2005 Kontron Modular Computers GmbH ID 29230, Rev. 01
29230
.01.UG.VC.050727/091440
P R E L I M I N A R Y
DESCRIPTION: To set or display the operational parameters for the available serial in-
terfaces the command “pf” is used.
At startup the settings for the SP4 and the SP6 interfaces are always
set to the default values (38400/8/n/1). This is to avoid a possible sys-
tem lockout. If other settings are required during operation of the Net-
BootLoader they may be made. If changes are made, it must be
ensured that corresponding parameters are used for the operator con-
sle.
Issuing this command without parameters being specified will display
the current serial port settings.
Syntax-wise, no spaces are permitted between the parameters and
they must be separated with a slash. Not all parameters must be
specified, but the “/” characters must be present to distinguish the
different parameters from each other. The sequence can be aborted
after every option.
USAGE: Set SP4 to 300 Baud, 7 Bits/char, odd parity, and 2 stop bits
COMMAND / RESPONSE (none):
pf term 300/7/o/2
Set the bits per character parameter of SP6 to 7
COMMAND / RESPONSE (none):
pf ser0 //7
Set the stop bits parameter of SP6 to 2
COMMAND / RESPONSE (none):
pf ser0 ///2
PF