Kontron VMP3 - Manual (Page 57)

VMP3 Installation
ID 29230, Rev. 01 © 2005 Kontron Modular Computers GmbH Page 3 - 3
29230
.01.UG.VC.050727/091427
P R E L I M I N A R Y
3. Installation
The VMP3 has been designed for easy installation. However, the following standard precau-
tions, installation procedures, and general information must be observed to ensure proper in-
stallation and to preclude damage to the board or injury to personnel.
3.1 Hardware Installation
The product described in this manual can be installed in any available slot of a VMEbus system.
However, to function as a system controller it must be installed in slot 1 (far left).
3.1.1 Safety Requirements
The module must be securely fastened to the carrier board using the mounting standoffs and
screws provided with the module.
In addition the following electrical hazard precautions must be observed.
Caution, Electric Shock Hazard!
Ensure that the system main power is removed prior to installing or removing
this board. Ensure that there are no other external voltages or signals being
applied to this board or other boards within the system. Failure to comply with
the above could endanger your life or health and may cause damage to this
board or other system components including process-side signal conditioning
equipment.
ESD Equipment!
This Kontron board contains electrostatic sensitive devices. Please observe
the following precautions to avoid damage to your board:
Discharge your clothing before touching the assembly. Tools must be dis-
charged before use.
Do not touch any on board components, connector pins, or board conductive
circuits.
If working at an anti-static workbench with professional discharging equip-
ment, ensure compliance with its usage when handling this product.