Kontron AM4211 - Manual (Page 68)

53 AM4211
www.kontron.com
To set this setting, the [-s|--set] option has to be appended.
-X | --core <0-100%>
This option configures the Maximum power usage for each core of the the Cavium processor.
To set this setting, the [-s|--set] option has to be appended.
-w | --power <20-40 WATTS>
This option configures the maximum power budget for the AM4211.
To set this setting, the [-s|--set] option has to be appended.
Power(w) Throttling(%)
-------------------------
<20W 10%
20W 10%
27,5W 100%
>27,5W 100%
Power = (Throttling + 230) / 12
-k | --clock <CLOCK>
This option configures the QLM0/1 clock reference source.
Possible configurations are:
0 QLM0/1 use local AMC clock.
1 QLM0/1 use external FCLKA signal from the AMC connector.
To set this setting the [-s|--set] options has to be appended.
-s | --set
This option sets the configuration in the MMCs NV ram, updates the FRU data multirecord and performs a MMC
reset (IPMI Cold Reset).
-c | --cycle
This option send the IPMI command "Chassis control Power cycle" to the MMC to perform a payload power
cycle. During the power cycle the configuration will be enabled. This option is allowed without any other
options or when a valid PCIe or Interface setting is configured and activated with the
[-s|--set] option.
Note:
FCLKA input may be damaged if driven by an M-LVDS driver.