Kontron KISS 2U Short KTQ67 - Manual (Page 24)

7. Product Description KISS 2U Short V2 – User’s Guide (V1.00)
7.2.2.3.
Additional Ports
Depending on the installed motherboard, your system cam be equipped with on-board interfaces (e.g. serial interface)
routed to the rear panel (refer to Fig. 15, pos. 9 and Fig. 16, pos. 7). These ports allow you to connect different
peripherals.
Information and technical data can be found in the corresponding board manual of the installed
motherboard. You can download the relevant board manual for your system configuration from our web
site at
www.kontron.com by selecting the product name.
Refer also to the “KISS 2U Short V2 Systems - Configuration Guides” on our web site.
7.2.3. Power Supply Unit
The KISS 2U Short V2 is equipped with an AC wide range PSU (Fig. 15 and Fig. 16, pos. 4). On request only, it can be
equipped with a +24VDC or a -48VDC PSU. For information about the integrated power supply unit (PSU) and the rated
voltage of your system, please refer to the type label attached on the right side of the unit.
7.2.4. Grounding Stud
The grounding stud is located on the rear side of the KISS 2U Short V2 platform (Fig. 15 and Fig. 16, pos. 1).
The KISS 2U Short V2 systems with marked grounding studs with a PE symbol have to be grounded by
establishing a large-area contact between the grounding stud and an appropriate grounding
connection point.
Fig. 19: Grounding stud marked with PE symbol Fig. 20: Unmarked grounding stud
7.2.5. Fan Slide-In Module and Temperature Sensor
The two system fans are securely installed in a user-friendly fan-slide-in module (Hot-Swap). The fan slide-in module is
mounted in the fan compartment on the front of the device.
The systems fans are temperature-controlled via the temperature sensors which are built in the system. The systems fans
ensure a sufficient airflow for an optimal, active cooling of the system.
The operation of the KISS 2U Short V2 platform is permitted only with a functional fan slide-in module
(refer to the section 10.1 “Replacing System Fans”).
Defective components may be replaced only by Kontron original spare parts.
❏ part number of the fan slide-in module: 1050-8442
22 www.kontron.com