Cleaning the filter mat, 2 “cleaning the filter mat, Clean the filter mat regularly (see section 10.2 – Kontron KISS 2U Short KTQ67 User Manual

Page 38: Section 10.2 “cleaning the filter mat

Advertising
background image

10. Maintenance and Prevention

KISS 2U Short V2 – User’s Guide (V1.00)

10.2. Cleaning the Filter Mat

The filter mat is inserted in the filter mat holder at the front side of the fan slide-in module (Fig. 40, pos. 4). The soiling of
the filter mat is caused by the pollution of the operating environment. A heavily soiled filter mat can cause excessive
heating of the device. For this reason we recommend to clean the filter mat as often as necessary. The filter mat can be
replaced during operation of the system.

1

2

3

5

4

5 Fan slide-in module

4 Front access panel

3 Filter mat holder with knurled screw

2 Filter mat

1 Front side of the KISS 2U Short V2

platform

Fig. 40: Detail with filter mat holder on the fron side of the KISS 2U Short V2 platform

To replace the filter mat, proceed as follows:

1.

Open the front access panel (Fig. 40, pos. 4).

2.

Loosen the knurled screw that secures the filter mat holder to the fan slide-in module (Fig. 40, pos. 3 and
Fig. 42, pos. 5).

3.

Pull the filter mat holder out from the centring holes (Fig. 41, pos. 3) in the direction marked with the arrow
(Fig. 40) and lift it off.

4.

Remove the dirty filter mat.

5.

Clean the filter mat as follows:

❏ Rinse in water (up to approx. 40°C/104°F; you may add a mild commercial detergent).

❏ It is also possible to beat it, suction clean it or blast it with warm compressed air.

❏ If the filter is soiled with greasy dust, you should rinse it with warm water with degreaser added. Do not clean the

air filter mat with a piercing jet of water or wring it out.

6.

After cleaning and drying the filter mat, place it in the filter mad holder (see Fig. 43).

7.

Reattach the filter mat holder to the front side of the fan slide-in module by inserting the centring latches
(Fig. 42, pos. 6) into the centring holes (Fig. 41, pos. 3).

8.

Fasten the filter mat holder by tightening the knurled screw (Fig. 42, pos. 5) to the bolt with tapped hole
(Fig. 41, pos. 1) at the fan slide-in module.

Defective components may only be replaced by Kontron original spare parts.

Air filter mat: part number: 1050-8374.

36

www.kontron.com

Advertising