Kontron KISS 2U Short KTQ67 - Manual (Page 30)

8. Installation and Removal KISS 2U Short V2 – User’s Guide (V1.00)
8.2.1.1.
Installing/Removing Low Profile Expansion Cards
In order to install/remove low profile expansion cards perform the following steps:
1. Open the unit as described in the subsection 8.2.1 (step 1 to 5).
2. Unscrew the fastening screws of the slot bracket or card slot bracket (Fig. 29, pos. 1). Retain the screws for later use.
3. Insert/remove the expansion card/s in respectively out from the expansion slot/s of the motherboard and secure the
card brackets or the slot brackets to the rear with the retained screws.
3 2
1
Fig. 29: Detail KISS 2U Short V2 with KTQ45/Flex (system configuration for low profile cards)
1 Fastening screws for the slot brackets (or for the card slot brackets if expansion cards are
installed)
2 2x PCI slots for expansion cards (max. length of the card: 230 mm)
3 2x PCIe slots for expansion cards (max. length of the card: 230 mm)
4. Close the system and secure the cover with the captive knurled screw at the front side and the two captive knurled
screws on the rear side.
In order to close the KISS 2U Short V2 platform chassis, ensure that the cover is reinstalled properly and
secured with following screws:
❏ the cover fastening screw (Fig. 11, pos. 6) and Fig. 25) on the front side
❏ the knurled screws (Fig. 15, pos. 6, Fig. 16, pos. 8 and Fig. 26) on the rear side
28 www.kontron.com