Kontron KISS 2U Short KTQ67 - Manual (Page 27)

8. Installation and Removal KISS 2U Short V2 – User’s Guide (V1.00)
8.
Installation and Removal
8.1. Attaching the Rubber Feet
If the system is used as desktop version, attach the supplied rubber feet to the device.
Before attaching the rubber feet, ensure that your system is switched off and disconnected from the
main power source.
To attach the rubber feet, proceed as follows:
1. Turn off the system and disconnect it from the mains power source.
2. Turn the device upside down on a table or desk.
3. Ensure that all components are securely installed and that the device cover has been screwed on tightly.
4. Remove the protective film from the rubber feet.
5. Stick the four rubber feet to the underside of the device.
www.kontron.com 25