Drives cage physical assembling procedure – Kontron KISS Stor 0/5 User Manual
Page 32
Installing the KISS-Stor 0/5
KISS-Stor 0/5 – User’s Manual
31
Drives Cage Physical Assembling Procedure
Please observe that the drive carrier must be unlocked, in
order to insert (completely) the drive carrier into the drives
cage of the KISS-Stor 0/5. The key-lock is unlocked if the
key is in a vertical orientation. (refer to
fig. 14
)
1.
Turn the key-lock to the unlocked position.
2.
Insert successively and slide each of the drive carrier into a corresponding bay
of the drives cage (refer to
fig. 11, pos.5
).
3.
Gently push the drive carrier until it connects to corresponding receptacles on
the rear of the drives cage of the KISS-Stor 0/5 (refer to fig.
11, pos. 4
).
4.
Insert successively the key into each of the drive carrier lock, turn the key one
quarter turn to the RIGHT, and make sure that the mechanical lock is ensured.
Fig. 14: Drives cage assembling