Kontron KISS Stor 0/5 - Manual (Page 8)

Safety Instructions
KISS-Stor 0/5 – User’s Manual 7
Safety Instructions
Please read this section carefully and observe the instructions for your own safety
and correct use of the device.
This chapter also contains information on approval and interference suppression
of your KISS-Stor 0/5.
Please observe the warnings and instructions on the device and in the manual.
The device has been built and tested by Kontron Embedded Computers in
accordance with EN 60950/VDE 0805 and left the company in a perfectly safe
condition.
In order to maintain this condition and ensure safe operation, the user must
observe the instructions and warnings contained in this manual.
q
The KISS-Stor 0/5 is designed to be built into a system. The integration into
the system has to be done such, that the system complies with the
IEC/EN 60950 safety rules.
q The device must be used in accordance with the instructions for use.
q The electrical installations in the room must correspond to the requirements of
the respective regulations.
q Only devices and components which fulfill the requirements of a SELV circuit
(Safety Extra Low Voltage) in accordance with EN 60950 may be connected
to the interfaces of the system.
q The device is designed to be used in horizontal position.
q Repairs may only be carried out by a person authorized by Kontron
Embedded Computers.
q Maintenance or repair on the open device may only be carried out by qualified
personnel authorized by Kontron Embedded Computers which is aware of
with the associated dangers.
q
The device may only be opened for installation and removal of SATA hard
disks in accordance with the instructions in this manual.
q The computer system must be switched off and disconnected from the power
source before installing a SATA hard disk.
q It must be assumed that safe operation is no longer possible
· if the device has visible damage or
· if the device no longer functions.
In these cases the device must be shut down and secured against
unintentional operation.