Mercedes-Benz E-Sedan 2010 Owners Manual - Manual (Page 322)

recommended to have such work done by a
qualified technician.
Before you start to replace a bulb for a front
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
$.
X Open the hood ( Y page 223).
Releasing/fixing the washer fluid
reservoir
To replace bulbs of the driver’s side
headlamp, the washer fluid reservoir in the
engine compartment must be released.
X Releasing: Turn screw ;
counterclockwise and remove it.
X Tilt washer fluid reservoir : to the side as
far as necessary to access the headlamp
bulbs.
X Fixing: Tilt washer fluid reservoir : back
into fixing position.
X Fasten screw ; by turning it clockwise.
Low beam (halogen headlamps only)
X Driver’s side only: Release the washer fluid
reservoir (
Y page 320).
X Turn housing cover : counterclockwise
and remove it.
X Turn bulb socket ; counterclockwise and
pull it out.
X Pull the bulb out of bulb socket ;.
X Insert the new bulb into bulb socket ;.
X Insert bulb socket ; into the housing and
turn it clockwise.
X Align housing cover : and turn it
clockwise.
X Driver’s side only: Fix the washer fluid
reservoir (
Y page 320).
High beam (halogen headlamps only) or
Corner-illuminating lamp (Bi-Xenon
headlamps only)
320
Replacing bulbs
Practical hints
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 320