Practical hints, Flat tire – Mercedes-Benz E-Sedan 2010 Owners Manual User Manual
Page 329
X
Guide the spare wheel onto the alignment
bolt and push it on.
X
Insert the wheel bolts and tighten them
slightly.
X
Unscrew the alignment bolt.
X
Install the last wheel bolt and tighten it
slightly.
X
Vehicles with spare wheel with
collapsible tire: Continue the procedure
by following the instructions under
“Inflating the collapsible tire”
(
page 327) and then “Lowering the
or
X
Vehicles with Minispare wheel: Continue
the procedure by following the instructions
under “Lowering the vehicle”
(
Inflating the collapsible tire
G
Warning!
Inflate collapsible tire only after the wheel is
properly attached.
Inflate the collapsible tire using the electric
air pump before lowering the vehicle.
G
Warning!
Observe safety instructions on air pump label.
!
Do not lower the vehicle before inflating
the collapsible tire. Otherwise the rim may
be damaged.
Your vehicle may be equipped with either of
two versions of the electric air pump:
R
Version 1: The air hose with pressure
gauge and the electrical plug are located
behind a flap.
R
Version 2: The pressure gauge is located
in the pump housing. The air hose and
electrical plug are located at the bottom of
the pump housing.
The following description applies to both
versions. Differences in usage are expressly
declared.
Version 1
Version 2
X
Version 1 only: Open flap : on electric
air pump.
X
Version 1 only: Pull out electrical plug
= and air hose with pressure gauge and
vent screw ?.
X
Version 2 only: Pull electrical plug = and
the air hose out of the pump housing
bottom.
X
Version 1 only: Close vent screw on air
hose ?.
X
Remove the valve cap from the collapsible
tire valve.
X
Screw union nut A onto the collapsible tire
valve.
X
Make sure air pump switch ; is set to
0.
X
Insert electrical plug = into the cigarette
lighter socket (
Flat tire
327
Practical hints
212_AKB; 2; 41, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 327
Z