Rice Lake 920i Programmable HMI Indicator/Controller - EtherNet/IP Interface - Manual (Page 8)

4 520/720i/820i/920i EtherNet/IP Install & Programming Manual
.
Figure 2-6. EtherNet/IP 520 Backplate Cable Assembly
10. The indicator automatically recognizes all
installed option cards when the unit is
p o w e r e d o n . N o h a r d w a r e - s p e c i f i c
configuration is required to identify the
newly-installed EtherNet/IP interface to the
system.
DIP Switch Function
Setting any one of the DIP switches to the ON
position will set a static IP address when the indicator
i s p o w e r e d u p . T h i s I P a d d r e s s w i l l b e
192.168.0.XXX where the XXX = DIP switch setting.
Example: If switch #8 is ON, and the rest are OFF, the
static IP address will be 198.168.0.1. If switch #7 is
ON and the rest are OFF, the IP address will be
192.168.0.2.
2.2 EtherNet/IP Network Connections
Feed the EtherNet/IP network cable through the
indicator cord grip. Allow enough cable for routing
along inside of enclosure to connector on the
EtherNet/IP module. Connect network cables to
connector on the EtherNet/IP module (see Figure 2-4),
then use cable ties to secure network cables to the
cable tie mounts.
Note To configure an IP Address, refer to
Section 3.1 on page 6.
2.3 LED Status Indicators
An LED array on the EtherNet/IP module provides
status info rmation fo r tro ub le sho oting (se e
Figure 2-7):
• LED 1 provides status about the link
• LED 2 provides status information about the
EtherNet/IP module
• LED 3 provides network status
• LED 4 flashes whenever a packet is sent or
received
1
2
3
4
Activity
Module status
Link status
Network status
Figure 2-7. EtherNet/IP Status LED Module
LED 1: Link Status
Table 2-1. LED 1 Status
LED 1 Color State Description
Green On Module has a link
Off Link not sensed
Table 2-2. LED 2 Status
LED 2 Color/State Description
Steady off No power to module
Steady green Module operating correctly
Flashing green Module not configured
Flashing red Recoverable fault detected
Steady red Internal error detected
Flashing red/green Performing power-on self-test