Rice Lake SURVIVOR LV Series Livestock Ring Scale - Manual (Page 8)

4 590 AG Indicator Operators Manual
1.3 Display Annunciators
The 590 AG Indicator display uses a set of LCD annunciators to provide additional information about the value
being displayed. Figure shows these annunciators and their meanings.
Gross mode
Net mode
Standstill
Center of zero
Tare - Not Available
Low battery
lb
kg
Displayed units
Secondary
Primary
Group mode group
Figure 1-2. Display Annunciators
Table 1-1. Description of Display Annunciators
Symbol Description
G The displayed weight is a gross weight.
N The displayed weight is a net weight.
Scale is at standstill or within the specified motion band. Some operations, including zero, tare, and printing
functions, can only be done when the standstill symbol is shown.
0
Center of zero. Gross weight is within 0.25 graduations of zero. This annunciator lights when the scale is zeroed.
Tare features are not available on the 590 AG.
Indicates that the battery charge is low.
lb, kg, group Three arrow annunciators on the right side of the LCD display indicate the units associated with the displayed
value. The bottom arrow annunciator (group) is lit when the indicator is in group mode. The top and middle
arrows, labeled lb and kg, show primary and secondary units, as described below:
• If the displayed weight is in pounds, the top arrow (lb) is lit; if kilograms, the middle arrow (kg) is lit.
• If the primary unit of weight is pounds, the middle (kg) arrow is lit for secondary units—or, if the primary unit is
kilograms, the top (lb) arrow is lit for secondary units, unless the secondary unit of weight is the same as the
primary unit.
• If neither primary nor secondary units are pounds or kilograms, the top arrow is used as a primary units
annunciator and the middle arrow is used as the secondary units annunciator. A set of replacement overlay
decals is included in the parts kit for units other than pounds and kilograms.
• If the indicator Display Hold Mode is enabled, the current unit annunciator will blink when holding the display.
Note
See Section 3.2.2 for information about configuring primary and secondary display units.