Rice Lake 880 Performance Series Panel Mount Indicator/Controller - Modbus TCP Interface Option Installation and Programming Manual - Manual (Page 14)

10 Modbus Interface Installation and Programming Manual
3.0 Configuration Procedure
3.1 Configuring the Network settings
Configuring the network setting can be done using a web browser or the Anybus IP
configuration utility.
Open a browser and just type the IP address of the card. Change any or all the setting
and then click on the Store configuration button.
To set the network settings using the Anybus IP Configuration program.
1. Open the Configuration program found on the CD.
2. Click on the Scan button if the device does not appear in the window.
3. Once the device is found double click on the device found in the window.
4. A window will be displayed with the current network settings.
5. Change any or all setting and click on the Set button.
Figure 3-1. Modbus Interface Screen Using your Web Browser