Rice Lake 880 Performance Series Panel Mount Indicator/Controller - Modbus TCP Interface Option Installation and Programming Manual - Manual (Page 6)

2 Modbus Interface Installation and Programming Manual
2.0 Installation
This section describes the procedures used to install the Modbus TCP Interface into
the an indicator.
2.1 Installing the Modbus Interface
Figure 2-1. Modbus TCP Interface Kit
Disconnect power before removing indicator backplate.
Use a wrist strap to ground yourself and protect components
from electrostatic discharge (ESD) when working inside the
indicator enclosure.
1. Disconnect indicator from power source.
2. Unplug all connectors from the back of the controller assembly.
PN 156669 Backplate, Controller
PN 152359 Module, Modbus
PN 153093 Option Card
Also included in kit:
PN 14825 Screw, Mach 4-40NC x 1/4" Qty 4
J1
J2
J4
WARNING
CAUTION