Rice Lake 920i Bulkweigher 107 - 108 - 109 - Manual (Page 25)

Sequence of Operation for System 109 (Shipping/Receiving Mode) 21
4.3 Sequence of Operation for System 109 (Shipping/Receiving Mode)
The following instructions explain a basic sequence of operation for the 920i Flexweigh Systems 109 (Shipping /
Receiving Mode operation). This system allows the user to select between shipping or receiving modes of opera-
tion depending on the user selected position of a front panel switch.
Changing the selection of the shipping/receiving switch during an ongoing bulkweighing process is disregarded
and displays an error.
The only time switching between shipping and receiving modes is allowed is when the system is in the idle state between
completing a bulkweighing process and pressing the
Start/Resume button to initiate a new bulkweighing process.
4.4 End Cycle
An automatic cycle for either System 107 or 108 may be concluded at any time by pressing the E-Stop button.
Note
The front panel E-Stop button must be in the stopped position (pushed in) to enable any of the following
keypad entries.
1. Release the E-Stop button on the front of the unit and also press the End Cycle button.
2. The system turns on end cycle pressed flag.
3. The system checks that the printer is online. (If it is not, the system is stopped in the printer offline error state).
4. The system prints end cycle with a time and date stamp.
5. If the system is at steps 1 through 7 in the sequence, the system then advances to step 7 of the end cycle.
6. If the system had started a fill in the sequence, terminate the fill process and resume the sequence from that
point:
• Steps 7 through 17 of the Systems 107 Bulkweighing (Shipping Mode)
• Steps 9 through 17 of the Systems 108 Bulkweighing (Receiving Mode)
If the system has started a discharge in the sequence, resume the discharge from where it left off and
continue through step 18 of the sequence.
7. The system checks that the printer is online. If it is not, the system is stopped in the printer offline error state.
8. The system prints total accumulated weight, time and date, and ID#1 and ID#2 (if not disabled).
9. The shipping/receiving sequence is ended; the system returns to the idle state.
4.5 Manual Abort Mode
If the system has an optional manual/off/auto selector switch to allow changing from automatic to manual modes of
operation, select the manual position for use only while the system is in an idle state. After completing an auto-
matic cycle through all sequence steps and before pressing
Start for a new automatic sequence, the system will
immediately end the cycle and print end on the automatic cycle at that point.
4.5.1 System 107 Shipping Mode of Operation
If the system is set to manual during the filling cycle, the cycle is halted and aborted. The current accumulated total
of draft net weights is the completion of the shipping cycle, after jumping to steps 15, 16, and 17 in sequence.
If the system is set to manual during the discharging cycle, the cycle is halted, and the current scale weight is
recorded as the empty weight (step 14) and the cycle is aborted after performing steps 11-18, and then 22.
4.5.2 System 108 Receiving Mode of Operation
If the system is set to manual during the filling cycle, the cycle is immediately halted and aborted. The current weight is
recorded as the full weight (step 12), jumps to steps 13-14, and then completes the cycle with a printed report.
If the system is set to manual during the discharge cycle, the cycle is immediately halted, and the final printed
report is generated using the current accumulated total of draft net weights.
No automatic sequences or printing/recording capabilities are provided in the manual mode.
4.6 Accumulator Streaming
The current total received weight will be streamed to a remote display. It also streams in shipping mode.