Rice Lake 920i Installation Manual V3.13 - Manual (Page 55)

Configuration 49
3.2.7 ALGOUT Menu
The ALGOUT menu is shown only if the analog output option is installed. If the analog output option is
installed, configure all other indicator functions and calibrate the indicator itself before configuring the analog
output. See the Analog Output Card Installation Instructions, PN 69089, for more information.
Figure 3-17. Analog Output Menu
ALGOUT Menu
Parameter Choices Description
Level 2 submenus
SOURCE1 PROG
SCALEn Specifies the scale tracked by the analog output. PROG indicates that the analog output is under
program control.
MODE1 GROSS
NET Specifies the weight data, gross or net, tracked by the analog output.
OFFSET 0%
20% Zero offset. Select 0% for 0–10 V or 0–20 mA output; select 20% for 4–20 mA output. This
parameter must be set before calibrating the analog output.
ERRACT FULLSC
HOLD
ZEROSC Error action. Specifies how the analog output responds to system error conditions.
Possible values are:
FULLSC: Set to full value (10 V or 20 mA)
HOLD: Hold current value
ZEROSC: Set to zero value (0 V or 4 mA)
MIN 000000
0–9999999 Specifies the minimum weight value tracked by the analog output. Specify a value in the range
0–9999999.
MINNEG OFF
ON Specify ON if the minimum weight (MIN parameter) is a negative value.
MAX 10000
0–9999999 Specifies the maximum weight value tracked by the analog output. Specify a value in the range
0–9999999
MAXNEG OFF
ON Specify ON if the maximum weight (MAX parameter) is a negative value.
Table 3-11. Analog Output Menu Parameters
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
number
40
number
SOURCE
PROG
OFFSET
20%
0%
ERRACT
SCALE n
FULLSC
HOLD
ZEROSC
TWZERO
59650
TWSPAN
MODE
GROSS
NET
If SOURCE1 ≠ PROG
n = slot number of analog output card
ALGOUTn ALGOUT n+14
If dual-channel card
installed
number
10000
ON
MIN
number
000000
MINNEG
ON
OFF
MAX
OFF
MAXNEG