Rice Lake TP Series, Rice Lake Weighing Systems - Balance Manual - Manual (Page 11)

Operation 7
5. Put the cover on top of the balance and place the complete assembly along the guide.
6. Secure the exact level of the balance by turning the adjusters (feet) until the bubble rests in the center of the red circle
on the level.
• Round-pan type: total of two adjusters, one on either side at front of balance.
• Square-pan type: total of four adjusters, one on either side at the front and rear of balance.
Figure 2-3. Level the balance by turning the adjusters.
Use caution when operating the adjusters on the square-pan type to prevent them from lifting up.
7. Connect the AC adapter to the balance, as illustrated below.
Figure 2-4. Connect the AC Adapter.
2.2 Operation
1. When the AC adapter is connected to the balance, it displays [*]. Press . The display section will light up,
and the balance will be ready for operation.
2. Check the display for any missing indications or unlit parts. A few seconds after startup the indication is reset to zero.
Figure 2-5. Check the display.
3. To switch the measurement mode, press . Each time the key is pressed, the unit of measurement changes,
as indicated.
CAUTION
㻜 㻜 㻲 㻼㼏㼟
㼙㼛㼙
㻏
㼓
䠂