Rice Lake Lift Truck/Pallet Jack Scales - CLS-Series - Manual (Page 12)

8 CLS Series Service Manual
18. Back off upper and lower overload stops using a 1-1/8" wrench.
Figure 2-9. Overload Stops
19. Position a new load cell with its cable facing towards the center and opening of the S-beam facing the
flexures.
20. Install the top and bottom flexure rod with hardware ensuring that the flexure rod be oriented with the
short thread of rod facing nearest the load cell.
Figure 2-10. Installing Flexure into Scale
O v e r l o a d
stops looking
at top view.
Load cell cable should
f a c e t o w a r d s t h e
center of the scale.
S h o r t t h r e a d s
facing nearest the
load cell