Rice Lake Lift Truck/Pallet Jack Scales - CLS-Series - Manual (Page 6)

2 CLS Series Service Manual
2.0 Load Cell Replacement
This section describes procedures for replacing the load cell should it need to be changed. The CLS Series Cargo
Lift Scale uses Rice Lake’s load cell, PN 96198.
The following instructions must be followed exactly to allow for seamless and easy load cell replacement.
Take all necessary safety precautions when installing or replacing the scale parts including wearing safety
shoes, protective eyewear, and using the proper tools.
2.1 Required Tools for Replacing a Load Cell
The following list of tools is necessary for replacing a load cell on the CLS Series Scale. Ensure that you have
these necessary tools handy.
NOTE: Adequate light is necessary to change the load cell. Try to position the forklift close to a good source of natural
light or if not possible, have a good source of lighting available.
2.2 Load Cell Relacement
Figures 2-1 and 2-2 illustrate the parts associated with load cell replacement.
7ARNING
Rice Lake Part # Item Description
96196 Modified box wrench
Crescent wrench
3/4” Socket wrench, with extensions
Hammer
1-1/8” wrench for overload stop
Chisel
Allen wrench for overload stops
Digital voltmeter (capable of reading millivolts)
Torque wrench
Pry bar
Table 2-1. Required Tools for Replacing a Load Cell
Number RLWS Part Number Description
97883 Complete Replacement Parts Kit which includes all of the components listed below.
1 14671 Hex Nut
2 14671 Hex Nut
3 96249 Spherical Washer Set
4 Upper Block
5 96249 Spherical Washer Set
6 14671 Hex Nut
7 14665 Jam Nut
8 96199 Flexure Rod
9 14665 Jam Nut
10 96198 Load Cell
11 14665 Jam Nut
12 96199 Flexure Rod