Rice Lake SURVIVOR PL Rail Scale User Manual
Page 8
4
Survivor
®
PL
Installation Manual
4. Set longitudinal brackets (2) and side brackets (2) over pre-cast anchor bolts.
Check rod bracket
End rail support plate
Figure 2-3. Install Brackets
Note
The rods for the checking system, should be placed beneath the scale prior to setting of the modules.
5. Remove steel top plates from weighbridge module. Mark plates to identify location for re-assembly.
6. Install bearing block, upper mount plate, spacer tubes, bearing cushions, and shim plate in each load cell
pocket of weighbridge module.
Install upper load
cell components
Weighbridge module pocket
Ground strap
hole
When bolts are tight,
plates will be moveable
Figure 2-4. Upper Load Cell Plate Mounting Procedure
7. Set the weighbridge module on 5” setting blocks. Center the module between approaches.
WARNING
Crush hazard, keep hands, feet and other body parts clear when setting weighbridge modules in place.
Moving parts can crush and cut.