Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 26)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 20
How to set Memory Switch
1. Tharmal head cover is opened and push FEED switch more than 3 seconds. Re-write mode of
Memory Switch is activated. (ALARM red: flash)
2. Lift your finger off FEED switch, set Memory Switch on dip switch.
3. By pushing FEED switch, setting of dip switch is copied to Memory Switch. (ALARM red:light)
Return dip switch setting to original position, and thermal head cover is closed. The contents of
Memory Switch is printed for confirmation.
* Pleas do not forget to return Dip switch setting to original position.
* When you cancel Rewrite mode of Memory Switch, let thermal head cover be closed.
* After setting of Memory Switch, transition to the self print is not available when thermal head
cover is closed.
Fig.3 Installed Language Fonts
Installed language fonts MS2-2 MS2-3
Japanese OFF OFF
Chinese O N OFF
Korean OFF O N
Greek O N O N
* Japanse JIS C 6226 ：Full size
Katakana character set＋Extended graphic character set ＋Code Page 858＋International
character：Half size
* Korean KS X 1001:1992 ：Full size
Katakana character set＋Extended graphic character set＋Code Page 858 ：Half size
（ KS X 1001:1992 installed font）
* Chinese GB18030-2000 ：Half/Full size
* Greek Code Page1253 ：Full size (1 byte code)
Please refer to [select character code table] for other language.
4.1.3 Self Print
1) By performing self-diagnostic print following items are checked.
* Proper function of control circuitry
* Control F/W version
* Status of Dip switch setting and memory switch setting
* Correct function of paper out sensor
2) Start and end of self diagnostic print
Turn on the power while pressing the FEED switch and release the FEED switch after
initializing print mechanism. Self diagnostic print will take place.
The self diagnostic print automatically ends when a preset print pattern are printed.
While printing, the printer is in Off-line mode.
4.1.4 Paper sensor
Paper end sensor equipped in the paper course of the printer mechanism, and it detects
paper end status. It stops printing by error bit ON, when detected the paper end.
The sensor can not detect paper end glued to the core. Please exchange the paper roll
shortly after detecting the paper end.