Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 5)

D-F0446 NP-2511/3511 series Specifications Ver.0.07
Read Carefully Before Using the Printer
Wrong handling of the printer may cause its performance declined and the product damaged. Please read
the notes below before handling.
1. Static discharge prevention must be made for installation and removal of the printer to protect IC and
other electrical parts. Connect it to the earth ground. It is also requested to remove the static from body
of the person before handling, especially, the input terminal.
2. Avoid excessive force to the input terminal for handling.
3. Avoid printing with no paper loaded. It damages platen and thermal head, printer life will be shorten.
4. Do not scrabble thermal head with sharp edge or something hard, or give impact. The heat element
may be damaged.
5. Set the power of printer off before connecting or removing connecters.
6. The printer is not protected from water or dew formed. Do not water the printer or handle it with a wet
hand, which may cause damage to the printer due to short circuit, or heat or fire.
7. The printer is not protected from dust or dirt. If it is used at dusty place, the thermal head may be
damaged or paper feed is not operated properly.
8. When cooling the printer with a fan, avoid the printer’s paper outlet from locating fan’s air inlet. It may
cause mal-function of printer.
9. Reflection type of infrared ray sensors are used at some locations in the printer. Direct sun light may
cause mal-function of printer. Avoid from such a location for installation.
10. This printer does not support any operations caused by the commands or control commands not
specified in this manual.
11. Please use both hand when you hold the printer.
12. In order to prevent excess current, please put elemental device to external 24V power line (Please refer
to the power supply specification for the details), and also put fuse.
13. Please plug off the printer when you do not use the product for a long time. Please also insert paper
between the platen.
14. When paper jam occurred, please make sure to slowly remove the paper to paper exit direction after
head up status.
15. The product is designed to use with general electronic devices (Computer, PC, OA, others). This is not
designed and not guaranteed to use with extremely high quality, high reliability product or product whose
failure may danger human life (Atomic power control device, aerospace aircraft devices, Transportation
devices, Traffic signal devices, Ignition control devices, Medical devices, other safety equipments: we call
“Specific application” thereafter). Users take full responsibility for using with such specific application.
16. The product uses part that includes GaAS (Gallium arsenide). Please do not break the product, no
chemical splitting ,otherwise it may harm human with such part broken pieces.
17. The product should not be installed where it is tend to take place static easily, shaking strongly and
electromagnetic field, corrosive gas, rain, fog and direct sunlight.
18. There is some possibility that cut surface of steel plate on principal structural part of the product is to
rust easily.
19. Don’t re-create the product.
20. Don’t pull the paper while printing and paper-feeding. When thermal head cover is closed, don’t pull the
paper except for patial cut. When patial cut, you should pull either right or left on the edge of paper to
separate.
21. When you get rid of the proucting, you must dispose of according to local autholities.
22. In case the motor in engine of the product has been working for a long time or stopped and worked at
very short interval, the motor produces heat and doesn’t execised fully capacity. To avoid it, you should
get the motor stop for the same period of working time. The continuous working time is 6 minites one
time.
23. The coverage of warranty is limited within the product itself, Nippon Primex Inc is not responsible for
anything induced by the defect of the product, and don’t pay for any compensation.