Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 51)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 45
46) 【Setting of the height of barcode】《GS h n》
Code：〔1D〕h＋〔68〕h＋n ※〔 01≤n≤FF〕h
Sets the height of barcode by dot.
* n is indicated dot for horizental direction.
* The default of n is 〔A2〕h.（162dots）
47) 【Barcode Print】《GS k n Dn NUL》
コード：〔 1D〕h＋〔6B〕h＋n＋Dn＋〔00〕h ※〔 00≤n≤07〕h
Selects barcode symbology and prints barcode.
* The next print start position is set at the beginning of the line.
* Select following barcode symbology with “n” value.
n(hex) Barcode Symbology
00 UPC-A
01 UPC-E
02 JAN-13(EAN-13)
03 JAN-8(EAN-8)
04 CODE39
05 ITF
06 CODABAR(NW-7)
07 CODE128
* Dn indicates the character code to be printed.
* If character code Dn is not a printable character, following data after Dn will be treated
as normal print data.
* When the barcode symbology whose print character number is fixed is selected, the
character numbers should match to the print character numbers.
* If horizontal data exceed one line, the exceeded data cannot be printed.
* [00] h at the end of this command can be changed to [FF] h by [barcode end change]
48) 【Auto-Transmitting of Printer Status】《GS v NUL》
Code：〔1D〕h＋〔76〕h＋〔00〕h
When Print Status is changed, Auto-Transmitting is activated.
* Print Status is 1 byte and the contents as per details of error detection.
* Once the setting is done, it is effective until executing 【software reset】,reset switch
or power-off.
* This command is stored on internal reception input buffer, run by sequential.
49) 【Select horizontal size of Barcode】《GS w n》
Code：〔1D〕h＋〔77〕h＋n ※〔 02≤n≤04〕h
Select horizontal size of Barcode.
* Default of ｎ is〔03〕h.