Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 32)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 26
4.8 How to remove the jammed paper
- Pull up head open lever at the direction as illustrated.
- Remove all jammed paper on the route of paper.
- Close thermal head cover completely.(Until hearing click)
Attentions: Since the thermal head reaches a high temperature, please don’t touch it. If a
paper jam occurr, a cutter blade may stick out. DO NOT TOUCH IT.
4.9 How to clean Thermal Head
In case the heat generation part of the thermal head gets wisps of paper, the quality of print
may drop. In this case, you should clean the thermal head as following procedures.
1) Thermal Head
Remove wips of paper and grim with swab moistened alcohols solvent (ethanol / IPA) on
the heat generation part of thermal head. The use of methanol in alcohols solvent is
prohibited.
2) Platen
Remove wips of paper and dust on the surface by wiping like rubbing slightly with dry cloth.
3) Mark Sensor／No paper sensor and its surrounding
Remove wips and paper and dust on sensors with swab moistened slightly.
4) Attentions
・ Since the thermal head reach a high temperature shorly after printing, don’t touch it with
hands.
・ Don’t touch the heat generation part of thermal head with hands and metal materials.
・ When you clean thermal head, you should pay fully attention to the risk of breaking of
thermal head due to static electricity.
・
In case a lot of wips of paper are genrated depending on paper, timing of maintenaunce
should be decided after confirming the paper.
・
You should power on after completely driy on the printer.
Head Open Lever
* This is drawing of NP3511