Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 52)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 46
50) 【Print density set】《GS ~ n》
Code：〔1D〕h＋〔7E〕h＋n ※〔 41≤n≤87〕h
Set Print density in the range from 65% to 135%.
* Though n ranges〔41〕h(65%)～〔87〕h(135%),
set it for actual use in the range〔41〕h(65%)～〔82〕h(130%).
* Default of n is〔64〕h.
* When this command is used while 【Print set/Finish set】command, the setting is
disregarded.
51) 【Cue Operation】《Gs FF n》
Code: [1D] h + [0C] h + n ※〔 00, 10≤n≤11〕h
After detecting black mark, activate feed for preset alignment correction.
* n has following meaning.
n(hex) Description
00 Mark detection + feed to print start position
10 Mark detection + feed to cut position + full cut
11 Mark detection + feed to cut position + partial cut A
52) 【mark detection method & position correction feed quantity set】《Gs ( m a n1 n2》
※ [01≤m,a≤01] h
Code: [1D] h + [28] h + m + a + n1 + n2 ※ [01≤n1,n2≤FF] h
Set mark detection method and feed quantity of position correction.
* m, a, n1, n2 has following meaning.
Set item
m(hex)
Detecting method
a(hex)
Setting value
(n2*256+n1)
00 Upper edge
00
Feed quantity
to print start
position
01 Lower edge
Set a position from mark detection to print
start by dot.
00 Upper edge
01
Feed quantity
to cut position 01 Lower edge
Set a position from mark detection to cut
by dot.
* feed quantity is set by dot with signed 16bit(-32767~32767), upper Bit is set by n2,
lower Bit by n1.
* When feed quantity is set negatively, paper edge does not exeed back feed limit
(Please refer to cutter specification).
* Defaut is as follows:
Item Detecting mentod Preset value
Print start position Upper edge 92 dot ( 11.5mm: between sensor ~ head
Cutting position Uppder edge 168dot ( 21mm: between sensor~cutter )
53) 【cue process set at setting paper】《Gs m n 》
Code: [1D] h + [6D] h +n ※ [00≤n≤FF] h
Activate cue process set at setting a paper.
* each bit of n has a following meaning.
value
Bit Function
0 1
0 Cue operation after auto loading Invalidation valid
1 Cue operation after thermal head cover open/close Invalidation Valid
2 Cue operation after Feed switch push Invalidation valid
* this cue operation is same as selecting Gs FF [10] h
* default of n is [00] h