Crestron electronic C2N-DAP8RC - Manual (Page 46)

Digital Audio Processor with Room Control Crestron C2N-DAP8RC
42 • Digital Audio Processor with Room Control: C2N-DAP8RC Operations Guide - DOC. 8187A
The MUTE button and the up and down arrows at the lower right control the sound
being supplied to the available speakers indicated by the LEDs in the upper right
corner. The gauge shows the relative sound level.
The SOURCE SELECT pane is used to select the digital or analog audio source
material connected to the unit’s input ports.
The UTILITY pane lets you select the AUDIO or VIDEO switching utilities, or
SYSTEM SETUP.
The TONE CONTROL pane provides controls appropriate to the chosen audio
source and decoding mode. For example, the DYNAMIC RANGE selections MIN,
STD, and MAX, shown in the illustration, apply the indicated amount of
compression for Dolby Digital sources, as follows:
MIN provides the highest compression ratio, bringing dynamic range
close to that of a TV broadcast.
STD provides the dynamic range recommended by sound engineers for
general home viewing.
MAX provides the full dynamic range of a cinema.
System Setup
To begin, select SYSTEM SETUP. The display provides a set of buttons you use to
select the parts of the system to be configured—SPEAKER CONFIG, AUDIO
CONFIG, and EQ’S—plus AUDIO SWITCH and VIDEO SWITCH, which are
used to set the internal routing of audio and video signals. Initially, the large screen
area to the right is blank.
Select the first button, SPEAKER CONFIG. The screen displays the SPEAKER
CONFIG window.
SPEAKER CONFIG Window
Use this screen to specify the speaker arrangement of your system and to set the
crossover frequency for the subwoofer.