Crestron electronic C2N-DAP8RC - Manual (Page 49)

Crestron C2N-DAP8RC Digital Audio Processor with Room Control
Operations Guide – DOC. 8187A Digital Audio Processor with Room Control: C2N-DAP8RC • 45
a preset button (1 through 5), make adjustments, and press SAVE to store the
settings. To recall a preset, select the preset button; the stored settings are applied.
Audio Switching
Select the AUDIO SWITCH button to display the AUDIO SWITCHING window
used to select the analog audio source you wish to appear on the three possible
outputs.
AUDIO SWITCHING Window
This window lets you select the analog audio source that will appear on the CAT5,
OUTPUT A, and OUTPUT B audio output connectors. You can also choose to mute
the signal to those outputs.
The OUTPUT B CONTROLS section affects only the signals to OUTPUT B. The
BASS, TREBLE, and BALANCE controls are initially set to their middle positions;
the VOLUME control is set to its zero position.
The three buttons at the bottom provide both electronic and relay mute control of all
outputs, and a standard ‘loudness’ selection that provides emphasized treble and
bass. The electronic mute reduces the level of the output to –80 dB (effectively
silent); the relay mute opens the output circuits.
Video Switching
Select the VIDEO SWITCH button to display the VIDEO SWITCHING window to
specify the video output channel.
This screen lets you select any video source and route it to any video destination.
Choices range from routing the inputs from individual sources to individual
destinations through routing one source to all destinations. The VIDEO SENSE
indicators are lit if a video source is detected on VIDEO IN 5 through 16 connectors.