Symtech ATF 1 - Manual (Page 12)

11
9)
Check vehicle’s transmission fluid level. Add or extract fluid to obtain the proper fluid level by
selecting COOLER LINE mode. Select appropriate ADD FLUID or REMOVE FLUID button
on the control panel. READY light will turn on when either function is selected while awaiting
an amount to be entered on the corresponding display using the “+” or “- “ buttons of the
control panel.
READY light will turn off and the proper amount of fluid will be added or removed after
pressing the ADD FLUID or REMOVE FLUID button the second time. The unit resetting
signals the completion of fluid additions and removals and continuous alert will sound until
vehicle is turned off or COOLER LINE mode is selected.
Repeat procedure if necessary by selecting the COOLER LINE function again and performing
this step as required in order to obtain proper fluid level.
NOTE: If NEW fluid tank does not have enough fluid to perform the ADD FLUID function or
USED fluid tank does not have enough capacity to perform the REMOVE FLUID
function, the appropriate LED will light and beep indicating LOW TANK LEVEL in
NEW tank and/or HIGH TANK LEVEL in USED tank. Take appropriate actions to
correct fluid levels and then repeat step 9. See page 13 for instructions.
10)
Shut off vehicle. Disconnect hoses and adapters, reattach transmission cooler lines to original
connections, start vehicle to check for leaks, and recheck the transmission fluid level.
COOLER LINE exchange is now complete.
Cooler Line Exchange Process, Easy Reference
**NOTE: VEHICLETRANSMISSION FLUID SHOULD BE AT OPERATING TEMPERATURE PRIOR
TO PERFORMING ANY SERVICE WITH THE ATF1.
**NOTE: : THE ON BOARD BATTERY SHOULD BE AT FULL CHARGE FOR MOST
EFFICIENT FLUID EXCHANGE SERVICE, make it a habit to plug the on board battery
charger into a 110 volt service outlet after every 3 to 4 fluid services for efficiency and
extended battery life.
Preparation:
1.
Identify correct adapters, one male, and one female.
2.
Locate most convenient transmission cooler line, disconnect cooler line, connect adapters.
3.
Connect adapters to intermediate hoses and connect ATF1RED hose to one intermediate hose
and BLACK hose to other.
Operation:
1.
ConnectATF1to vehicle battery .
2.
Turn on Main Power.
3.
Start Vehicle, fluid pressure should register on meter.
IF no pressure is observed on meter, turn vehicle off and switch RED and BLACK
hoses – Start Vehicle.
4.
Select Cooler Line Mode.
5.
Enter total amount of fluid to be exchanged.
6.
Press Exchange Start.